Do you want to test 40/48 inputs version?

[gabriel1712]

I'm a bit confused about this...
With this expansion I will be able to add 8 stereo jack (teoretically 12) to the All-in-one 2.8 kit module, right?

[Synthex]

I'm a bit confused about this...
With this expansion I will be able to add 8 stereo jack (teoretically 12) to the All-in-one 2.8 kit module, right?

With Atmega32, you can add 8 inputs to the All-in-one 2.8 kit module = 4 stereo jack.
With Atmega644, you can add 24 inputs to the All-in-one 2.8 kit module = 12 stereo jack.

[gabriel1712]

Ah, right. Thanks and soz, if I'm asking obvious questions

I haven't recieved my kit yet and are building the box/jack inputs in the meantime. I'd like to take possible expansions into account.

I gather the v2.8 kit is shipped with the Atmega32 and can be upgraded to the Atmega644 at a later point.

[Synthex]

24 inputs extension for All In One v2.8 :

AllInOne_2.8_24_inputs_EXT.gif

[Synthex]

8 inputs extension for All In One v2.8 :

AllInOne_2.8_8_inputs_EXT.gif

[jeffbeckib]

Has this firmware been tested yet? I can't believe March is the last post on such a great upgrade??
Can I etch this daughter board? or does it have to be double sided

8 inputs extension for All In One v2.8 :

AllInOne_2.8_8_inputs_EXT.gif

[userfriendly]

6 wires... hmm. I guess, if I were to build a breakout box for input extension, I could use RJ-45 / TP for the connection between MegaDrum and the extension box?

[Rubis]

I would assume you can. I used to use RJ-45 all the time to connect the controller to my DDR pads. This seems very similar.

[userfriendly]

In any case, I'd need to make a breakout box: the 19" rack casing I got for my MegaDrum is 1U only. Should have gotten a 2U casing. Silly me.

Then again, it'll take me some time to make use of all 32 inputs on the MegaDrum anyway. Might not need more inputs for quite a while.

[userfriendly]

Btw, am I right in assuming that the circuit of this input extension would get its current from the external connector to the MegaDrum?